To wash hair extensions: brush them out first, wet the hair with lukewarm water while standing upright, massage sulfate-free shampoo into the scalp and let it run down the lengths, condition only from mid-lengths to ends (away from tapes, bonds and wefts), rinse well, squeeze dry with a towel and dry the attachment area completely. Wash installed extensions about every 2–3 days and clip-ins only every 15–20 wears.

Hands gently washing dark human hair extensions in a basin
Illustrative image

What you need

  • Sulfate-free, alcohol-free shampoo (for blonde or coloured hair: a shampoo for coloured hair)
  • Moisturising conditioner and, once a week, a hair mask
  • Wide-tooth comb or loop brush
  • Microfibre towel or soft cotton T-shirt
  • Heat protectant if you will blow-dry

Washing installed extensions step by step

  1. Brush first. Hold the hair near the root with one hand and brush from the ends up. Washing tangled hair makes knots tighter.
  2. Stay upright. Wash in the shower, not bent over a sink. Water should run from roots to ends, in the direction of the cuticle.
  3. Lukewarm water. Hot water softens keratin bonds and tape adhesive and dries the hair.
  4. Shampoo the scalp. Use a small amount and massage between the rows with your fingertips. Let the foam run down the lengths — do not scrub the extension hair or rub in circles.
  5. Condition the lengths. Apply conditioner from the middle to the ends, keeping it at least 3–5 cm away from the tapes, bonds or wefts. Comb it through with a wide-tooth comb and leave it 2–3 minutes.
  6. Rinse thoroughly. Leftover product near the bonds makes them slip and causes matting at the root.
  7. Towel dry by squeezing. Wrap and press; never twist or rub.
  8. Dry the attachment area completely, then the lengths (see drying and heat styling). Damp bonds and braids are the main cause of matting and odour.

Extra tips by type

TypeWashing tips
Tape-insWait 48 hours after installation before the first wash. No oil, silicone serum or conditioner on the tape.
Keratin tipsWait 48 hours. Separate the bonds with your fingers after washing so hair does not dry around them.
Micro rings and nano linksDry the rings fully so they do not slide.
Sewn-in or beaded weftsUse a nozzle applicator or diluted shampoo to reach the scalp between rows; dry braids with a cool dryer.
Clip-ins, halos, ponytailsRemove them and wash separately (see below).

Washing clip-ins and other removable pieces

  1. Brush each weft and close the clips.
  2. Fill a basin with lukewarm water and a little shampoo.
  3. Hold each weft at the top and dip it, smoothing the hair downward. Do not soak for long.
  4. Rinse under running water from top to ends.
  5. Apply conditioner to the lengths, leave 3–5 minutes, rinse.
  6. Lay flat on a towel or hang by the top and let air-dry. Brush gently when almost dry.

Mistakes to avoid

  • Washing every day — extension hair dries out faster than your own.
  • Sulfate or clarifying shampoos on coloured or blonde hair.
  • Going to bed with wet or damp hair.
  • Conditioner or oil on tapes and bonds.
  • Rubbing the hair with a towel.

Frequently asked questions

Can I use dry shampoo?

Yes, on your scalp and roots between washes. Brush it out well so it does not build up at the bonds.

What if my new extensions feel dry?

Hair can dry out during shipping. Wash once with a moisturising shampoo and conditioner, then use a few drops of light oil on the ends.

Why do blonde extensions lose colour when washed?

Some loss of tone in the first washes is normal for bleached and toned hair and then stabilises. Use cool water and a colour-safe or purple shampoo once a week for blondes.

Can I wash human hair extensions in a washing machine?

No. The movement tangles and breaks the hair and can damage clips and wefts.

Last updated: November 2026 · Written by the VietnamHairs team in Hanoi

Cart

No products in the cart.

What are you looking for?
Scope: